SP2

28/09/2004 - 10:12 por Rafael Herrero | Informe spam
Al instalar SP2 para XP me sale un error en Kernel al no
poder reiniciar el PC o similar que consulte el articulo
Q327101 en KNOWLEDGE BASE, lo busco y me dice que no
existe el articulo, alguien sabe como solucionarlo.
 

Leer las respuestas

#1 René López
28/09/2004 - 11:55 | Informe spam
Error message: Windows has detected that one or more
protected core system files (kernel) on your computer have
been modified
Se aplica a
This article was previously published under Q327101
SYMPTOMS
When you try to install Windows XP Service Pack 1 (SP1),
you may receive the following error message:

Windows has detected that one or more protected core
system files (kernel) on your computer have been modified.
The Service Pack contains updated versions of those files,
which work to provide a stable environment for your
programs. Due to this modification, the Service Pack will
not be installed. For more information, see Knowledge Base
article Q327101 at http://support.microsoft.com.
CAUSE
This behavior may occur if your computer has a modified
version of the Ntoskrnl.exe file that uses the /KERNEL
switch in the Boot.ini file. This condition may exist
because your computer has a third-party program installed
that customizes the graphics that are displayed when your
computer starts up. Third-party programs that can cause
this condition include the following:
BootXP
LogonUI Boot Randomizer
RESOLUTION
To resolve this problem, follow these steps:
Click OK to close the error message.
Click Start, click Run, and then type appwiz.cpl in the
Open box.
Click the program that customizes the startup graphics,
and then click Remove.
Restart your computer, and then try to install SP1 again.
If the problem persists, go to step 5.
On the desktop, right-click My Computer, and then click
Properties.
Click the Advanced tab, and then click Settings under
Startup and Recovery.
Under System Startup, click Edit.

The Boot.ini file opens in Notepad.
Locate and then delete the /KERNEL= switch.
Save and then close the Boot.ini file.
Restart your computer.
Try to install Windows XP SP1.
NOTE: After you complete the steps to resolve the problem,
SP1 should install correctly. However, if your computer is
running a modified Ntoskrnl.exe file, you may receive a
message when you try to install SP1 that states that the
SP1 setup program will replace the modified Ntoskrnl.exe
file with an updated version.
STATUS
This behavior is by design.
MORE INFORMATION
For additional information about this issue, click the
following article number to view the article in the
Microsoft Knowledge Base:
327120 Error Message: Windows Service Pack 1 Has Detected
That One or More Protected Core System Files on Your
Computer Have Been Modified

The third-party products that this article discusses are
manufactured by companies that are independent of
Microsoft. Microsoft makes no warranty, implied or
otherwise, regarding the performance or reliability of
these products.
The information in this article applies to:
Microsoft Windows XP Home Edition SP1
Microsoft Windows XP Professional SP1
Last Reviewed: 6/16/2004 (3.0)
Keywords: kbenv kberrmsg kbbug kbnofix KB327101

Al instalar SP2 para XP me sale un error en Kernel al no
poder reiniciar el PC o similar que consulte el articulo
Q327101 en KNOWLEDGE BASE, lo busco y me dice que no
existe el articulo, alguien sabe como solucionarlo.
.

Preguntas similares